1 has060zh-a 45 50 55 60 65 70 75 80 85 90 10 20 30 40 50 60 70 80 90 100 load % efficiency % eff. (36v) eff. (48v) eff. (72v) has060yh-a 60 65 70 75 80 85 90 10 20 30 40 50 60 70 80 90 100 load % efficiency % eff. (18v ) eff. (24v ) eff. (36v ) ? industry standard half-brick low-cost design open-frame packaging 100c baseplate operation 24v and 48v inputs optional enable logic 1500v isolation input pi filter general description features notes ? mtbf predictions may vary slightly from model to model. specifications typically at 25c, normal line, and full load, unless otherwise stated. soldering conditions: i/o pins, 260c, ten seconds; fully compatible with commercial wave-soldering equipment. safety: agency approvals may vary from model to model. please consult factory for specific model information. units are water-washable and fully compatible with commercial spray or immersion post wave-solder washing equipment. efficiency vs. load (48v input) efficiency vs. load (24v input) voltage range 24 vdc nominal 18 - 36 vdc 48 vdc nominal 36 - 72 vdc reflected ripple 25 ma input reverse voltage protection shunt diode input technical specifications output setpoint accuracy 1% line regulation v in min. - v in max., i out rated 0.2% v out load regulation i out min. - i out max., v in nom. 0.2% v out remote sense headroom 0.5 vdc minimum output current 10 % i out rated dynamic regulation, loadstep 25% i out pk deviation 4% v out settling time 500 s voltage trim range 10% short circuit / overcurrent protection hiccup current limit threshold range, % of i out rated 110 - 140% ovp trip range 115 - 140% v out nom. remote shutdown reference v in negative shutdown pin current, sourced at off 10 ma max. has series - 60 watt has dc/dc converters are low-cost, industry standard, half-brick converters. the has features 2:1 input voltage, excellent efficiency, and open-frame packaging technology. the has operates over a range of -40c to 100c and has a built-in input pi filter that helps to ensure low noise operation. available in several input and output combinations, the has is designed for industrial, telecom, and networking applications. turn-on time 10 ms remote shutdown positive or negative logic switching frequency 500 khz isolation input - output 1500 vdc input - case 1050 vdc output - case 500 vdc temperature coefficient 0.03%/c case temperature operating range -40 to +100c storage range -40 to +125c thermal shutdown range 105 to 115c humidity max., non-condensing 95% vibration, 3 axes, 5 min each 5 g, 10 - 55 hz mtbf ? (bellcore tr-nwt-000332) 2.5 x 10 6 hrs safety ul, cul, tuv weight (approx.) 1.4 oz rev. jun 07, 2002
2 natural convection 7.9 c/w 100 lfm 6.8 c/w 200 lfm 4.9 c/w 300 lfm 3.6 c/w 400 lfm 3.0 c/w tolerances mechanical drawing 1-v in 2 case 3 on/off 4+v in 5-v out 6 -sense 7 trim 8 +sense 9+v out inches: (millimeters) .xx 0.020 .x 0.5 .xxx 0.010 .xx 0.25 pin: 0.002 0.05 (dimensions as listed unless otherwise specified.) thermal impedance note: thermal impedance data is dependent on many environmental factors. the exact thermal performance should be validated for specific application. pin function 1 2 3 4 5 6 7 8 9 0.700"(17.8mm) -0.50"(-12.7mm) 1.400"(35.6mm) 1.000"(25.4mm) 0.400"(10.2mm) 0 0.18" 2.40" (61.0mm) 2.28" (57.9mm) pins 5 & 9 only dia 0.080" 0.025" ref. 0.50" (12.7mm) (4.6mm) (2.0mm) dia 0.040" (1.0mm) mounting inserts m3x.5 through 4pl (0.6mm) bottom view 1.900" (48.3mm) -0.19" (-4.8mm) 0 has series - 60 watt model input voltage input voltage maximum input output rated output ripple & noise typical (volts) range (volts) current (amps)* voltage (volts) current (amps) pk-pk (mv) efficiency** has040ye-an 24 18-36 2.8 3.3 12 100 80% has050yg-an 24 18-36 3.5 5 10 150 81% has050yh-a 24 18-36 3.4 12 4.2 100 84% has060zh-a 48 36-75 2 12 5 150 85% notes: * maximum input current at minimum input voltage, maximum rated output power. ** at nominal v in , rated output. models - (see the last page of section for options.) rev. jun 07, 2002
3 option suffix applicable series remarks negative logic n has, hbd, hbs, hes, hls, hld, les, ttl "low" turns module on qbs, qes, qls, tes, tqd ttl "high" turns module off lucent-compatible t has, hbd, hbs, hes, hls, qbs, qes, qls terminal strip ts xws, xwd, xwt trim 1 ias, les enable 2 iad, ias, les, sms trim and enable 3 ias, les current share 4 sms headerless y encapsulated ews, iws, ows pin length and heatsink options standard pin length is 0.180" (4.6mm) 0.110" (2.8mm) pin length 8 all units (except sms) 0.150" (3.8mm) pin length 9 all units (except sms) 0.24" (6.1mm) horizontal heatsink 1h all units (all units except dip, hls, hld, qls, includes thermal pad sip, sm, tld, and tkd packages) 0.24" (6.1mm) vertical heatsink 1v all units (all units except dip, hls, hld, qls, includes thermal pad sip, sm, tld, and tkd packages) 0.45" (11.4mm) horizontal heatsink 2h all units (all units except dip, hls, hld, qls, includes thermal pad sip, sm, tld, and tkd packages) 0.45" (11.4mm) vertical heatsink 2v all units (all units except dip, hls, hld, qls, includes thermal pad sip, sm, tld, and tkd packages) 0.95" (24.1mm) horizontal heatsink 3h all units (all units except dip, hls, hld, qls, includes thermal pad sip, sm, tld, and tkd packages) 0.95" (24.1mm) vertical heatsink 3v all units (all units except dip, hls, hld, qls, includes thermal pad sip, sm, tld, and tkd packages) when ordering equipment options, use the following suffix information. select the option(s) that you prefer and add them to the model number. example ordering options are located below the options table. example options: hbs050zg-ant3v = hbs050zg-a with negative logic, lucent-compatible trim, and 0.95? vertical heatsink. les015yj-3n = les015yj with optional trim and enable, negative logic. qbs066zg-at8 = qbs066zg-a with lucent-compatible trim and 0.110? pin length. options nuclear and medical applications - power-one products are not authorized for use as critical components in life support systems , equipment used in hazardous environments, or nuclear control systems without the express written consent of the respective divi sional president of power-one, inc. technical revisions - the appearance of products, including safety agency certifications pictured on labels, may change dependi ng on the date manufactured. specifications are subject to change without notice. rev. jun 07, 2002
|
